BPS C-100 Manuel de service télécharger pdf (Page 26)

Installation Leuze electronic

24 BPS 37 Leuze electronic

Connection BPS direct

Figure 6.6: Connection BPS direct

Notice!

Ensure adequate shielding. Connections 1 and 2 must be twisted pairs and the total connec-

tion line must be shielded and grounded at one end.

Attention!

It is absolutely necessary to connect the protective conductor, since all electrical interfer-

ence (EM pick-up) is discharged via the protective conductor connection.

Connection of the protective conductor PE

BPS 37 without cable KB 031-3000: connect PE to the housing of the BPS 37 or to the

housing of the 15-pin SUB-D connector!

BPS 37 with cable KB 031-3000: connect PE to the wire with bl/wh colour coding or

connect it to the shield!

BPS with cable and MA 4.7 (MA 4D.7): connect PE to PIN 21 or PIN 22!

SSI DATA +

SSI DATA -

SSI Clock +

SSI Clock -

SSI DATA +

SSI DATA -

SSI Clock +

SSI Clock -

3

4

6

9

BPS 37 SM 100 Control/drive

SSI interface

Pin

Connection 1

Connection 2

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 37 38

Commentaires sur ces manuels

Pas de commentaire